How to Troubleshoot Refrigerator Ice Maker Repair


Appliance Repair Training Online Course
How to Troubleshoot Refrigerator Ice Maker Repair – Not Making Ice… this works for all brands; kenmore, Whirlpool, Kitchenaid is a Simple Appliance Repair
How to fix a refrigerator ice maker that is not making ice is really not that hard when you follow these easy steps. In this video you will learn how repair or fix your refrigerator ice maker that has stopped making ice or making small ice cubes….
This video shows you how to diagnose the problems associated with the ice maker not making ice… you will want to watch this video.
Here is Where You Will Learn the most probable fix to get your refrigerator making ice again
Top 5 Reasons a Refrigerator Ice Maker is Not Making Ice
Some of the more common causes of a Refrigerator Ice Maker Repair Not Making Ice;

  1. Freezer Temperature in Refrigerator is too High – should be set between -0 – 5 degrees
  2. Defect Water Inlet Valve – they can fail electronically or mechanically
  3. Water Pressure is too low – check the water pressure coming from the wall faucet
  4. Frozen Supply Tube – check the tube that fills the ice maker to ensure it is not frozen
  5. Faulty Door Switch – check door switch with a mult-meter for ohms of resistance
LG Washing Machine Diagnostic, Troubleshooting & Repair Guide… Check List

Washer Troubleshooting Guide

Symptom Check

Click on underlined items for further information

Washer does not work and makes no noise

Washer does not work but it does make noise
 

No water is entering the wash tub
– or no hot water
– or no cold water

The water fills the wash tub too slowly

The tub does not fill with enough water

  • Test the water level switch

  • Check that the drain hose is positioned roughly as high as the top of the inner tub

The water overflows the wash tub

Water drains out during the wash or rinse cycle

  • Check the drain control lever

  • Test the drain control coils

  • Check the cam bar

  • Test the timer control

Wrong temperature of water is used

  • Water supply hoses may be reversed

  • Hot or cold water supply valve may be turned off

  • Water supply hose may be kinked

  • Check water inlet valve

Water drains out while it is filling

  • Check the drain hose, it should be at least as high as the top of the wash tub, about 38 inches.

  • The drain hose must sit loosely in the house drain. Do not seal the air gap around the drain hose or a siphon will occur.

  • Check the drain control lever

  • Test the drain control coils

  • Check the cam bar

Water drips into the wash tub when the washer is off

Water does not drain out of the wash tub

Water is leaking onto the ground

  • Inspect the water supply connections

  • Inspect the drain hose

  • Inspect the water pump

  • Inspect outer tub for cracks or corrosion

  • Inspect the tub seal

  • Inspect the tub bearing

Agitator does not move

Agitator movement is weak or moves in only one direction

  • Inspect the agitator

  • Inspect the motor coupler

  • Inspect the drive belt (belt drive only)

  • Inspect under the washer for soot (clutch)

  • Test the motor

  • Inspect the pulley

  • Test the transmission

  • Inspect the pump coupling

Drum does not spin

  • Test the lid switch

  • Test the timer control

  • Test the centrifugal switch

  • Test the water level switch

  • Inspect the motor coupler

  • Inspect the drive belt (belt drive only)

  • Inspect under the washer for soot (clutch)

  • Test the motor

  • Inspect the pulley

  • Test the transmission

Clothes are too wet after spin cycle

This may be a spin problem or a drain problem

Drain:

  • Make sure the drain line is clear

  • Check the drain hose for a partial blockage

  • Inspect the water pump

Spin:

  • Test the lid switch

  • Test the timer control

  • Test the centrifugal switch

  • Test the water level switch

  • Inspect the motor coupler

  • Inspect the drive belt (belt drive only)

  • Inspect under the washer for soot (clutch)

  • Test the motor

  • Inspect the pulley

  • Test the transmission

Cycle does not advance

  • If the washing machine fills with water and begins agitating, but the timer does not advance, the timer probably needs to be replaced

  • If the timer does not advance while the washer is in a spin cycle, the timer probably needs to be replaced

  • If the timer does not advance during the rinse cycle, check whether water has filled the tub, if not, it is likely cold water related. Check the cold water supply valve, check the supply hose for kinks, check the filter screen and check the water inlet valve

Burning or electrical smell

  • Unplug the washer

  • Locate the source of the odor then read the instructions in the related section

Foul or stale odor coming from washer or clothes

  • Check that the drain line is clear

  • Check the drain hose for kinks or blockages

  • Check pump for blockages

  • Check for build up of soap in the outer tub

  • Check for article of clothing stuck in the outer tub

Noisy or vibrates too much

  • General tips

  • Balance the load

  • Level the machine

  • Inspect the water pump for a blockage

  • Inspect the coupling

  • Inspect the transmission

  • Adjust the drive belt tension

  • Check the motor bearings

  • Check the drum brakes

Goes out of balance too often

Clothing is damaged

  • Inspect agitator for cracks or rough spots

  • Inspect for rust spots
How to Repair an LG Washing Machine is Easy with Step-by-Step Videos…

LG Washing Machine Leaking Water from the Bottom
Find LG Washer Discount Replacement Parts with Overnight Shipping..